I need to have my kitchen faucet & garage disposal replaced. Thank you,

Anna H

I would like an estimate on a gas tankless water heater

Keith C

Shower valves stripped and unable to turn handles to turn on water to bath tub/shower. Wondering if valve stems and or fixture can be replaced.

Emanuel B

I'd like an estimate to replace garbage disposal. I would like a 3/4 hp.

Ernest R

I have a leak on the house side of my water meter, at the first connection, right past the meter.

Ron H

Bath tub drains terribly slow. Takes up to 20 minutes to empty. Tried drain solutions but they did not work.

William S

Just installed a new bath tub(second floor) and the drain pipe/fitting is off center to the right of the tub hole by approxamtely 3-4 inches. There is no give left on the piping to make it fit. It is all PVC schedule 40 pipe and I think 2 inch diameter??; and is all glued on every joint with PVC glue/the vent pipe seems to fit but is canted ever so slightly so it dosn't fit well; I believe it needs to be extended 1 inch?? I need the Tub plumbed correctly. The copper pipe/spout is too low on the water action and needs to be raised approxametly 3 inches and the water action needs to be raised about 4 inches/It is all braised copper pipiping; 1/2 inch I think, and has compression fittings on the top of the water action (copper pipe going to the shower head)-That needs to be adjusted as well to fit on the new souround I am putting in.

Stephen F

I need a new toilet installed. Thanks,

Mark D

I would like to switch from electric cooking to gas. We have a gas furnace and water heater, so hopefully adding another line won't be too difficult, but before I begin, I need to get a rough estimate how much this will cost. Help! Thank you,

Marie W

I have a leak in casing of 1/3hp Less than 3 yr old insinkerator disposer; would like to upgrade to 1/2 hp with installation and longer life product

Greg A